Draw Full Radius Edge

You can create a full radius edge on Step 2 using either the Full Radius option or by adding a Bump-Out Arc. If you chose Full Radius, no material will be added to the length of the edge to create the depth of the arc. If you chose Bump-Out Arc, then CounterGo will add the depth of the arc to the length of the countertop. 

bump out arc or full radius

  1. To create arc that adds material to length, select Add Bump-Out Arc.

    add bump out arc

  2. Enter the Depth and Width.

    enter depth and width

  3. To create arc that does NOT add material to length, select Full Radius.
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us